Advertisement
Quick Links
SainSmart.com
NCS1
Intelligent communication converter manual
First,
General
NCS1 is RS485 and RS232 to the TCP / IP intelligent communication converter, it
offers both RS485 and RS232 to TCP / IP network, as well as TCP / IP network to the
RS485 and RS232 transparent data transmission, it converter RS485 and intelligent
communication the data received on the RS232 serial port, transparent transmission
of data to the network server, data server data issued by the network at the same time
conveying to intelligent communication converter, RS485 and RS232 serial port.
The NCS1 10M/100M Ethernet interface up and down a standard RS485/422 and an
RS232 serial port communication parameters can set your browser, the baud rate
from 110bps ~ 115200bps. Applicable to a variety of network environments.
Second, Hardware Description
The NCS1 positive as shown below:
The NCS1 interface diagram:
Ethernet: RJ45 network interface, use the interface through the network line of
intelligent communication converter access TCP / IP network.
RS-485/422: T-(B) T + (A) R + R-interface, insert supporting the expansion board.
Power: Power connector, the input voltage DC 9 ~ 24VDC (recommended 12V).
RS232: Standard DB9 connectors.
Third, Software settings
Advertisement
Summary of Contents for SainSmart NCS1
- Page 1 First, General NCS1 is RS485 and RS232 to the TCP / IP intelligent communication converter, it offers both RS485 and RS232 to TCP / IP network, as well as TCP / IP network to the RS485 and RS232 transparent data transmission, it converter RS485 and intelligent...
- Page 2 Methods of operation: Double-click the running SmartSetGUI.exe, menu bar, click the "Setup", click the drop-down "Search" or click the Quick Launch bar "Search", and then select the device NCS1, double-click or click the Quick Launch bar "Setup"enter the device information bar.
- Page 3 “IP Address”: In this key to enter the IP address used by the NCS1; select the “ DHCP:Enabled ”, the ignored. “Net Mask”: In this input the NCS1 by use of the IP address corresponding to the mask; select the “ DHCP:Enabled ”, the ignored.
- Page 4 SainSmart.com 4,Sockets "Mode": In general the automatic mode for “TCP Auto” or “TCP Client”. 5，Device “Device” “Name”:To change the device name “Password” “Status”:Disabled or Enabled; Select "Disabled" that the use of a password, select "Enabled" and with a password can be modified.
- Page 5 IP in the same segment; When not on the same network, the need to first computer's IP is set to the same network segment. 2，Must take the NCS1 The IP is set not used in the LAN IP to prevent IP conflict. Fifth,Warranty Description 1，Free technical support...