Page 1
Rotation Counter Installation Manual For EZ/TMR xx10 Series Indicators Ft. Atkinson, Wisconsin USA Panningen, The Netherlands www.digi-star.com D4044-EN Rev B September 15, 2015...
Introduction INTRODUCTION Thank you for equipping your Digi-Star Scale System with the Rotation Counter feature. The Rotation Counter Sensor allows the scale Indicator to both; count the number of revolutions of the PTO shaft, and track when the PTO is on. This in turn allows the scale Indicator to utilize the Rotation Counter function, record Hours of Use, and properly display a Maintenance Message.
Installation Instructions INSTALLATION INSTRUCTIONS The Rotation Counter Sensor can be installed on any shaft or sprocket that is directly coupled to the mixer’s primary mixing rotor or auger. If the mixer is equipped with a transmission or gearbox that provides a neutral or de-coupled setting the Rotation Counter must be installed downstream on the mixing rotor or auger side of the transmission or gearbox.
Page 6
Installation Instructions 4. Attach Rotation Counter Sensor Mounting Bracket as shown in Figure 2. 5. Adjust sensor to 1/8” (3mm) from target as shown in Figure 3. Figure 3: Rotation Counter Sensor Adjustment 6. Connect the “Y” Cable as shown in Figure 1. 7.
Page 7
Installation Instructions Alternate installation directly on a rotor or auger shaft Alternate installation on a jack shaft Alternate installation on drive or drive sprocket Installing the sensor to pick up the teeth on drive or driven sprockets is also possible. D4044 Rotation Counter Installation Manual for EZ/TMR xx10 Series Indicators...
Indicator Setup INDICATOR SETUP INSTRUCTIONS To turn on Rotation Counter function on Digi-Star EZ/TMR xx10- Series Indicators 1. Enter 4301 press (Enter 421 on older Digi-Star EZ3 Indicators.) 4301 2. Press to pick COUNTR (REV on EZ3) option. 3. Press 4.