Selecting A Location; Components And Controls - KDAR SPG Operator's Manual

Selecting A Location

The WFG Welder should be placed where clean cool air can easily flow through the vents in the front of the
unit. Dirt and dust can be drawn into the unit resulting in excessive operating temperatures and shutdowns,
therefore, dirt and dust around the unit should be kept to a minimum.
The WFG Welder should be placed on a stable, level surface suitable to hold the unit's weight.

Components and Controls

1. Trigger Assembly
2. Spool Tension Knob
3. Spool Tension Spring
4. Shielding Gas Nozzle
5. Contact Tip
6. Wire Tension Adjustment Knob
7. Wire Drive Roll
8. Idle Roll
9. Lead Cable
10. Straight Gun Tube
11. Spool Cover
12. Spool Cover Retaining Knob
5
4
1
9
10
Installation/Setup
7
8
6
2
3
12
11
Notes
KDAR Company 6