Advertisement
Frequently Asked Questions
Q: How do I know the USB A type is ready for device?
A: After connecting PC1 to one "the USB2.0 2-port manual share switch" port by a
USB cable, the LED of PC1 will blink couple times and keep light on, which
means PC1 has right to use the device.
Q: How do I know the hot key is ready?
A: After 2 PCs are connected to "the USB2.0 2-port manual share switch" by 2 USB
cables, the LED of PC1 will blink couple times and keep light on. After this
process, the LED of PC1 will blink couple times again and keep light on, which
means the PC2 has right to use hot key.
Remark:
Please don't switch the right of use during data transferring. It will
cause the data lost.
Certificate
FCC
This equipment has been tested and found to comply with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received. Including interference
that may cause undesired operation.
CE – Certificate
This equipment is in compliance with the requirements of the following
regulations: EN 55 022: CLASS B
DISCLAIMER
Information in this document is subject to change without notice. The manufacturer does not
make any representations or warranties (implied or otherwise) regarding the accuracy and
completeness of this document and shall in no event be liable for any loss of profit or any
commercial damage, including but not limited to special, incidental, consequential, or other
damage.
No part of this document may be reproduced or transmitted in any form by any means,
electronic or mechanical, including photocopying, recording or information recording and
retrieval systems without the express written permission of the manufacturer.
4
Advertisement
