Advertisement
2. Take out the screws and spacers from
bag at back of cabinet. Place the
spacers onto screws and then put
the screws in the hole where the
handle is to be installed. Please make
sure the spacer is correctly in place
before you put the screws in the hole.
3. Align the handle with screws,
tighten the screws using a screw
driver until the handle is both flush
and secured tightly against the
door side. (DO NOT over-tighten as
this may cause damage to the door
surface)
4. After handle fixed well, put the door
seal back to the door to cover the
hole.
emove all the internal and external
IN STA LL ATI ON
f the appliance prior to first use. We
The appliance is designed to be built-in,
h warm water then rise and dry.
recessed or free standing installation.
nce after cleaning.
The minimum space required is:
nce shall not be made by children
830H x 615W x 605D (mm)
615
nding
stallation
of time can cause a significant increase
For a complete guide, refer to user manual,
ents of the appliance.
page 10.
ers.
ary.
e. The compressor will not run during
e anti-stop position when fully loaded.
used exclusively for the storage of wine.
ave the door closed as much as possible
mperature. Should the power failure
ou should take steps to protect the
st a rise in temperature. The wine
temperature setting and revert to
stored.
D E TAI L S
Size (mm):
820—880H x 595W x 575D
M O D E L
/
Door seal
Congratulations on your new
InAlto Dual Zone Wine Centre!
I W C D 4 6 . 1
Defrosting
The wine cooler is designed to defrost automatically every 4 hours. The defrost
During defrost, the compressor stops working and fan keeps on running for 20
Q U I C K S T A R T G U I D E
Door alarm
The wine cooler is equipped with an alarm that will sound if the door is left open
or press any key once to switch off the alarm.
Controls
It is recommended that you install appliance in a place where the ambient temp
ambient temperature is above or below recommended temperature, the perfor
example, placing your unit in extremely cold or hot conditions may cause interi
operation temperature range may not be reached.
1
Upper zone display
TH E CON TRO L S
To switch the power on/off
Your Wine Cellar Centre Controls
Press and hold the power button for 6 seconds to switch the wine cooler on.
Press and hold the power button for 6 seconds again to switch the wine coo
1
Power Button
Press and hold the power button for 6
To change the temperature
seconds to switch the beverage centre on
Continue to press the "+" or "-" buttons for the appropriate zone until the requ
The preset temperature is 8C/46F for the upper zone and 12 C/54 F for lowe
and off.
To change the temperature display from Fahrenheit to Celsius, or Celsius to F
3
Upper Zone "+" Button
button at the same time for 2 seconds. Tips, please see the "
Press to increase the set temperature shown
The display shows the current internal temperature when the wine cooler is o
on the display.
Optimal temperature selection
4
Upper Zone "-" Button
Whilst wine is best stored at temperatures between 13 and 15 C , your wine c
Press to decrease the set temperature
As a guide for red wine this is between 15 and 17 C, and for white wine betwe
shown on the display.
To use the internal light
3
Lower Zone "+" Button
Press the light button to switch the light on or off.
To turn the light ON when door opens, press the light button for 6 seconds, t
Press to increase the set temperature shown on
door controls function is ON
the display.
To turn the light function OFF, press the light button for 6 seconds, the display
4
Lower Zone "-" Button
control function is OFF.
Press to decrease the set temperature
shown on the display.
To lock the whole panel
6
Light Button
Press power button and "+" button at the same time for one second, all the b
Press power button and "+" button once again, all the buttons will be unlocke
Press to turn the internal light on and off.
For a complete guide, refer to user manual,
Tips, please see the "
page 9.
SUPP O RT
Telephone: 1300 11 4357
Email: support@residentiagroup.com.au
Normal Height
2
3
8 12
Lower zone display
" symbol on control panel.
W W W . I N A L T O . H O U S E
After Adjust
Key:
4
5
6
1 - Power button
2 - Upper zone
"+" button
3 - Upper zone
"-" button
4 - Lower zone
"+" button
5 - Lower zone
"-" button
6 - Light button
o
o
" symbol on
o
o
Advertisement
