Advertisement
4.2.
ADJUSTING THE HELMET TILT (SEE FIG.3)
4.2.1.
If the visor is too low when the helmet is in the lowered position, adjust the tilt of the helmet in relation to the headband.
4.2.2.
Referring to fig.2, loosen the external thumbwheels and lift the tab up to move it to make the helmet tilt up further or to tilt down
further. Then re-tighten the external thumbwheels.
5. MAINTENANCE
5.1.
CHANGING THE VISOR
5.1.1.
Release the stud from the body of the brow guard (fig.4).
5.1.2.
Release the two clips from under the vent (fig.5).
5.1.3.
The visor will swivel on the two visor pegs and can be gently pulled free from the body of the brow guard (fig.6).
5.1.4.
To install the new visor reverse the above process.
5.2.
CLEANING AND DISINFECTION
DO NOT use abrasive materials.
8
5.3.
Using a soft and clean brush or cloth, use warm suds to wash and clean. Ensure hands are clean (without grease).
5.4.
Materials which may come into contact with the wearer's skin could cause allergic reactions to susceptible individuals. The contact
areas should be disinfected regularly.
5.5.
INSPECTION
5.5.1.
The visor should be periodically inspected and cleaned to keep it clear. In case damage damage to the visor, please replace.
5.6.
Ensure a correctly specified lens is fitted as a replacement (see Specification section).
Ensure hands are clean (without grease) while fitting the lens.
6. STORAGE
6.1.
Good storage conditions are very important for the service life of face shield. It should be stored at temperatures higher than 5°C
and lower than 40°C and 90% relative humidity. It should be kept away from solvents, solvent vapours or any corrosive materials,
because the protection effect of face shield may be seriously reduced.
6.2.
It is recommended that you put it in a protective bag or box when not in use and store them in a safe place.
fig.6
7. SHELF LIFE/EXPIRY DATE
7.1.
Product shelf life/expiry date is 2 years from date of purchase.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fig.3
01284 703534
sales@sealey.co.uk
Original Language Version
fig.5
fig.4
www.sealey.co.uk
SSP78.V2, SSP78.V2R Issue 2 02/11/2020
Advertisement
