Dytran ENIDINE ENI-VIBE 33VC4400B Quick Start Manual

ENI-VIBE ™ Configuration:
Refer to the Operating Guide for comprehensive instructions for various scenarios. One scenario is outlined below:
1. Before data recording can begin, a configuration file must be created on the Micro-SD
configuration file, insert the Micro-SD
device reader, open the Eni-Vibe™ Analysis Software Toolkit and select the SD card drive.
a. Open the Eni-Vibe™ software and click the Create Configuration File tab
b. Go to the File Explorer window and locate the SD Card Drive. Click
navigate to the Eni-Vibe™ drive. Click Select Folder.
c. Click
appear (See image on the right) Click OK.
NOTE: For the purposes of this quick start guide, default setting values will be used. For
details on selecting different value settings, refer to the Operating Guide.
d. Click
verify the presence of the configuration file by opening your File Explorer window; it will be listed in
the Eni-Vibe™ drive.
2. After creating the configuration file, remove the Micro-SD
NOTE: Ensure the Eni-Vibe™ is powered off before inserting Micro-SD
ENI-VIBE ™ Data Collection:
1. To turn on the device, press the Power button
2. The Check/Ready
was just created
3. Once the device is satisfied with setup requirements, the Recording Status is ready when the light turns
green shortly after the Check/Ready light flashes.
NOTE:
a. To start recording, press the Record button. The Recording Status light will turn orange.
4. To stop recording, press the Record button again
5. The device will then save the current file and the Recording Status light will turn green to indicate that
the device is ready to record the next file
6. To turn off the device, press the Power button
ENI-VIBE ™ Data Transfer to Enidine:
1.
To view the data, eject the
2.
Open the folder, drag and drop the data file into an email, and send to industrialsales@enidine.com.
CONTACT US:
Quick Start Guide
ENI-VIBE ®
Operating Guides can be located on the Enidine B2B website at: b2b.ittcontroltech.com
® card into PC via Micro-SD
and the formatting confirmation window will
at the bottom of the screen and select Current Folder. You can
light will blink to indicate the presence of the Micro-SD
Recording Status
If is not flashing, refer to the Operating Guide for troubleshooting
Micro-SD ® card from the device and insert into the computer.
818-700-7818
MODEL 33VC4400B
® card slot or external Micro-SD
® card and insert into the Eni-Vibe™ device
www.dytran.com
® card. To create the
®
and
card to avoid file corruption.
®
® card and the configuration file that
info@dytran.com
card