Advertisement
Updating Procedure
NOTICE
Please save your important data onto the USB flash drive
before updating the firmware of the EAD10.
1.
After downloading, decompress the archived file, and then find the "***.PGM" file. Copy the
"***.PGM" file to the root of the USB flash drive.
2.
Make sure to turn the power off (the Standby/On switch is set to the Standby position,) and then
connect the USB flash drive to the [USB TO DEVICE] terminal on the rear panel.
3.
Hold down the [RECORDER] button, and then turn the power on by pressing the Standby/On
switch.
4.
Press the [
] (Click) button to start the update process.
This process takes a few minutes.
5.
When the update process is completed, following message will appear.
EAD10 Updater
Completed.
Boot * . * * → *.**
Firm * . * * → *.**
Reboot.
6.
Check the version of the firmware and you can turn the power off.
This completes the update process.
EAD10 Firmware Update Guide
3
Advertisement
