Table of Contents
Advertisement
Predator 32N
Owner's Manual
Before starting:
1. Check the floor carefully and remove all bolts, nails, as well as any loose material that
could get caught in the machine.
2. Fit the appropriate tools to the machine.
3. Fit splash guard to the right height.
4. Connect the power supply. Make sure you have all the phases. May have to check with
volt meter.
5. If you are grinding dry, connect the appropriate vacuum and start vacuum before starting
the grinder.
NOTE: IF THE WRONG POWER IS SUPPLIED TO THE GRINDER, IT WILL DAMAGE
THE ELECTRICAL COMPONENTS IN THE INVERTERS.
Starting machine:
1. Turn main power switch on side of power box to ON.
2. Turn forward or reverse switch left of right.
3. Turn manual speed pot up to get the heads turning for desired speed. (If heads do not
move, you may have to lean on handle to reduce pressure on tools.
4. Always grip handle firmly when starting machine. The machine will always move from
side to side with first start.
5. When finished with grinding, turn off machine and let the heads come to a complete stop
before tilting back the machine.
Changing of Tools:
1. Before working on the grinder, bring the motor to a total stop and disconnect power.
2. Tilt machine back on floor.
3. Use caution! Tools can be very hot from grinding. Use gloves.
4. Use special tool supplied to turn center of tool holder to remove tool plate.
5. Replace with new tool plate and turn to lock in place.
6. Lower machine back down and re-adjust splash guard is necessary.
OIPB-I02001-PREDATOR32N_V1.0
5.OPERATION INSTRUCTIONS
8 |
P a g e
0 1 / 0 7 / 1 9
Advertisement
Table of Contents
