Advertisement
PREPARATION:
- Only place this kiln on a heat-resistant floor or worktop. Please note that the worktop should be
very stable and be capable of safely supporting a MINIMUM of 50 kg of weight.
- Open the door and carefully remove all the accessories and packing materials from the cham-
ber.
- If the electrical box has not been attached to the kiln's body yet, attach it now:
Take the electrical box (Pic. 4, 5), which has three stainless steel legs (brackets), and screw it to the
kiln's body as shown in Pic. 7 and Pic. 8 using three screws (supplied).
Pic. 5 ELECTRICAL BOX MODELS 1100C & 1240P
Pic. 7
Now attach one end of the metal spring to the safety switch's pressing "finger" (Pic. 4) and attach the oth-
er end to the screw on the electrical box (Pic. 7, 9). When this is connected, attach the electrical box to the
heating elements (RED cables behind your kiln - Pic. 10) and the
next page:
2
Pic. 6 ELECTRICAL BOX MODEL RWF-1240P
Pic. 8
Pic. 9
safety mechanism,
as shown on the
Advertisement
