easymaxx H03 Operating Instructions Manual page 26

EN
The device can be operated either via the buttons on
the device or via the remote control.
1. Insert the mains plug into a properly installed socket that
is easily accessible.
2. To switch the device on you turn the ON / OFF switch (2) to
the I position. The display (6) fl ashes "25" (for 25 °C) and
the heating process starts.
3. You can set the required temperature (15 – 32 °C) to higher
with the + button (5 or 11) and to lower with the – button (9
or 12). The selected temperature has been reached when
the number in the display stops fl ashing.
4. With the speed regulator (8 or 13) you can set the speed
of the fan heater:
– HH – high speed
– LL – low speed
The device automatically stops heating as soon as
the preset temperature has been reached. Once it
cools down again the device begins heating again
automatically for as long as it is switched on.
5. To switch the device off you turn the ON / OFF switch to
the 0 position.
The device can be put into stand-by mode using the
ON / OFF button (10) on the remote control. Once the
ON / OFF button has been pressed, "– –" fl ashes on the
display of the device and is then constantly lit up. The
heating process is interrupted.
To switch the device on again, press the ON / OFF but-
ton on the remote control or any button on the device
itself. The temperature which has been set most recent-
ly appears on the display, and the heating process is
started again.
6. Allow the device to cool down and disconnect it from the
mains.
26