POWERZONE 1042 Important Safety Instructions

INS-PZ1042-12
750 Watt Halogen Work Light
Important safety instructions
WARNING: Read all instructions carefully
SAVE THESE INSTRUCTIONS
CAUTION: RISK OF ELECTRICAL SHOCK

Do not use with extension cord near water or where water may
accumulate.

Keep plugs and receptacles dry.

For use only on GFCI protected circuits.

Risk of burns, do not operate without guard. (See assembly instructions.)

Lighted lamp is hot. Keep away from combustibles. Unplug to change
bulb. Do not touch bulb
WARNING RISK OF FIRE, ELECTRIC SHOCK, EXPOSURE
TO EXCESSIVE UV RADIATION OR INJURY TO PERSONS

Unit operates on 120V AC 60 Hz only

Unplug and allow cooling before replacing bulb.

Bulb gets HOT quickly

Do not touch hot lens guard or enclosure.

Do not remain in light if skin feels warm.

Do not look directly at lighted lamp.

Keep lamp away from materials that may bum.

Use only with a 250 and one 500 Watt type T bulbs

Do not touch the bulb at any time; use a soft cloth or gloves. Oil from skin
may damage bulb.

Do not operate the lamp with
missing or damaged guard, lamp
containment barrier or UV light
filter.
SAVE THESE INSTRUCTIONS
WARNING: When using outdoor use work lights, basic safety precautions
should always be followed to reduce the risk of fire, electrical shock, and
personal injury, including the following:

Use only three-wire outdoor extension cords that have three-prong
grounding plug and receptacles that accept the appliance's plug.

Ground Fault Circuit Interrupter (GFCl) protection should be provided on
the circuit(s) or outlet(s) to be used for the wet location work light.
Receptacles are available having built-in GFCI protection and are able to
be used for this measure of safety.

Use only an extension cord for outdoor use, such as an extension cord of
cord type SW, SW-A, SOW, SOW -A. STW, STW-A, STOW. STOW-A.
SlW, SlW-A. SlOW. SlOW-A. SJTW. SJTW-A. or SJTOW, SJTOW-A.
BULB INSTALLATION AND REPLACEMENT
DO NOT TOUCH BULB WITH BARE HANDS
1. Turn the light off and unplug from the power source.
2.
3.
4.
5.
6.
7.
8.
ONE YEAR LIMITED CONSUMER WARRANTY
ONE YEAR LIMITED CONSUMER WARRANTY
This product is warranted to be free from defects to material and workmanship
for a period of ONE YEAR from date of purchase. If defective, the product will
be repaired or replaced. Contact your dealer and a customer representative will
attempt to help resolve any issue. If directed, return the product along with
proof of purchase to your dealer. Normal wear, damage due to abuse or
mishandling or unauthorized repair is not covered. This warranty does not
apply to accessories. This warranty gives you specific legal rights that vary
from state to state.
AVERTISSEMENT: LISEZ ATTENTIVEMENT TOUTES LES INSTRUCTIONS















Manufactured exclusively for Orgill Inc. Memphis, TN 3801
Allow the fixture to fully cool before proceeding.
Always wear gloves or use a clean cloth to handle bulb. The natural oil
from skin will leave a residue that will cause the light to burn out
immediately.
To remove the lens cover, remove the retaining screw on the back of the
lens cover. The lens cover will then swing open exposing the bulb.
To remove the bulb, grip one end of the bulb and gently push towards the
other end and pull outward to release the bulb.
Using a clean cloth or wearing gloves to hold the bulb, gently insert one
end of the bulb into the receptacle and press firmly into place. Place the
other end of the bulb into the opposite receptacle and gently press into
place. Make sure bulb is seated properly.
Close the lens cover and replace the retaining screw.
Do not test light without lens cover and guard properly attached.
WARNING: Read all instructions carefully
SAVE THESE INSTRUCTIONS
CAUTION: RISK OF ELECTRICAL SHOCK
750W Lampe de Travail Halogenes
Lire toutes les intructions attentivement
CONSERVEZ CES INSTRUCTIONS
ATTENTION: RISQUE DE CHOC ELECTRIQUE
Ne pas utiliser avec une rallonge pres d'un point d'eau ou d'accumulation
d 'cau
Garder les fiches et les prises de courant seches
Utiliser uniquement sur Ies circuits proteges GFCI
Risques de brulures. Ne pas utiliser sans I 'entourage (voir les
instructions d'assemhlage)
Risques d 'incendie / de blessurre. Tenir la lampe eloignee des
proudits combustibles Debrancher pour changer l' ampoule. Ne pas
toucher I' ampoule.
AVERTISSEMENT RISQUE D'INCENDIE, DE CHOC ÉLECTRIQUE,
EXPOSITION AU RAYONNEMENT UV EXCESSIVE OU DE BLESSURES
Fonctionne sur du l20V AC / 60 HZ uniquement
Debrancher et laisser refroidir avant de remplacer I' ampoule.
L'ampoule devient CHAUDE rapidement
Ne pas toucher la lentille, l'entourage le tout etant chaud.
Ne pas rester dans la lumiere si la peau devient chaude au toucher.
Ne pas reganrder la lampe allumee directement.
Tenir la lampe eloignee des produits inflammables.
Utilisez seulement avec un 500 et un 250 Watt ampoules de type T.
Ne jamais toucher ampoule, a aucun moment; utiliser un chiffon doux ou
des gants. Les huiles naturelles de la peau peuvent endommager la
lampe.
Ne pas faire fonctionner la lampe si tout ou partie de l'entourage, du
boitier (ou du flltre lumiere UV) est mamquany ou abime.