Advertisement
Quick Links
DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC
PHONE: 586-210-0555
WEB: www.cetinc.com
HVLP AIR CAP AND FLUID NOZZLE CHART
PRESS.
MODEL
AIR CAPS
NO.
SIPHON
23-1308
Pressure
23-1310
Pressure
FE-LINE
23-1312
Pressure
FINE
23-1313
Pressure
FINISH
23-1314
Pressure
(FEFF)
23-1315
Pressure
23-1317
Pressure
Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4)
*Note: Air cap test gages are available to confirm HVLP compliance.
*Gun inlet pressures may vary as required by application
*MAX GUN
OR
INLET PRESS.
CONTROL
FOR HVLP
29*
60-1317
FE-Line Fine Finish
SCFM @
STANDARD
FAN
MAX GUN
IN CAT
INLET
PACK
Included
13.5
Included
Included
PRESSURE FEED SPRAY GUN
PRODUCT INFORMATION
AVAILABLE FLUID
NOZZLES TIPS
33-0208 0.8mm (.022")
33-0210 1.0mm (.040")
33-0212 1.2mm (.046")
33-0213 1.3mm (.052")
33-0214 1.4mm (.055")
33-0215 1.5mm (.059")
33-0217 1.7mm (.070")
NEEDLES /
marking on needle
40-1808 (08)
40-1810 (1810)
40-1812 (1812)
40-1813 (1813)
40-1814 (1814)
40-1815 (1815)
40-1817 (1817)
Advertisement
Related Manuals for C.A. Technologies FE-Line Fine Finish
Summary of Contents for C.A. Technologies FE-Line Fine Finish
- Page 1 FE-Line Fine Finish PRESSURE FEED SPRAY GUN PRODUCT INFORMATION DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com HVLP AIR CAP AND FLUID NOZZLE CHART PRESS. *MAX GUN SCFM @ STANDARD MODEL AVAILABLE FLUID NEEDLES / AIR CAPS INLET PRESS.
- Page 2 FE-FF Operation and Maintenance Instructions for Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply to the gun fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice size and use the fluid control knob to “fine tune flow rate”.
- Page 3 HVLP AIR CAP TEST GAGES 23-1308-G 23-1310-G 23-1312-G 23-1313-G FE-FF 23-1314-G GUNS 23-1315-G 23-1317-G 23-1319-G 23-1322-G ITEM NO. PART NO. DESCRIPTION ITEM NO. PART NO. DESCRIPTION See Air Cap Chart Air Cap** 60-1312 Fluid Control Knob See Air Cap Chart Fluid Nozzle Tip** See Air Cap Chart Fluid Needle**...
- Page 4 FLUID NOZZLE / AIR CAP SELECTION CHARTS FE-FF Series - Pressure Feed Guns FE-FF HVLP SPRAY GUN FLUID ORIFICE x MAXIMUM MATERIAL TYPE PRESS. / SIPHON AIR CAP PATTERN WIDTH Very Thin less than 16 sec. Zahn #2 1.0 mm x 1310 inks , dyes, solvents, stains Thin...