WYSS TUMBLER 6550 Instruction Booklet page 9

125987711.qxp 2007-06-25
running, this button must be pressed again after
closing the door in order to restart the
programme from the point at which it was
interrupted.
This button must also be depressed after a
power failure and after having re-inserted the
water reservoir, if it has been emptied in the
middle of a programme after lighting up of the
"BEHÄLTER" light.
In both cases the light of the Start/Pause button
flashes to remind you that the start button needs to
be pressed again.
8 DISPLAY
The display shows the following information:
• duration of selected programme
• delayed start
• end of programme
• incorrect option selection
• alarm code
• Duration of selected programme
After you have selected the programme, its
duration (in hours and minutes) appears on the
display. It is calculated automatically on the basis
of the maximum load accepted for each type of
fabric and of the required degree of drying.
When the programme starts, the remaining time is
displayed every 5 minutes.
• Delayed start
If you have selected a delay time by means of the
relevant button, the display shows it for 3
seconds; then it shows the duration of the
previously selected programme.
The countdown is displayed every 30 minutes until it
displays "90 minutes" and then hour by hour.
10:45 Page 9
• End of programme
A zero indicates the end of the programme and it
is displayed after the "anti-creasing" phase.
• Incorrect option selection
If you select an option that is not compatible with
th e programme you have selected, the display
show s Err (error).
This code will reappear during the execution of the
programme if you press one of the option buttons or
turn the programme selector.
• Alarm code
In case of a functional anomaly, the display shows
an alarm code (e.g. E21). See page 14 for more
detailed information.
9