Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Promag AG19
- Page 2 Copyright© 2020 GIGA-TMS INC. Printed in Taiwan Any part of the contents of this document, without the express written GIGA-TMS permission, shall not in any documents, electronic, mechanical form of remakes or spread. File contents are subject to change without notice. Revisions Revision Date...
- Page 3 EMC EN55032 / EN55024 EMI Part 15 B EMI VCCI-CISPR 32...
- Page 4 Warning Federal Communication Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 5 LIMITED WARRANTY Giga-Tms warrants that the products sold pursuant to this Agreement will perform in accordance with Giga-Tms’s published specifications. This warranty shall be provided only for a period of one year from the date of the shipment of the product from Giga- Tms (the “Warranty Period”).
- Page 6 THE SOLE REMEDY SHALL BE REPAIR OR REPLACEMENT AS PROVIDED ABOVE. GIGA-TMS’S LIABILITY, IF ANY, SHALL IN NO EVENT EXCEED THE TOTAL AMOUNT PAID TO GIGA-TMS UNDER THIS AGREEMENT. IN NO EVENT WILL GIGA-TMS BE LIABLE TO THE BUYER FOR ANY DAMAGES, INCLUDING ANY LOST PROFITS, LOST SAVINGS, OR OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF, OR INABILITY TO USE, SUCH PRODUCT, EVEN IF GIGA-TMS HAS BEEN ADVISED OF THE...
-
Page 7: Table Of Contents
Contents Chapter 1 : Introduction................7 Introduce.......................7 Fitting........................7 Chapter 2 ： About AG19................8 Specification......................8 Chapter 3 ： How to use AG19..............9 Start to use AG19....................9 LED Indication......................9 DIP SW Setting....................10 Pin Description....................11 Connection......................12 Chapter 4 ： Troubleshooting..............15 Contact Us....................16... -
Page 8: Chapter 1 : Introduction
Further clean the hands of entering personnel detection and control. To ensure a safe and clean place in the control area. Before using the AG19 . We recommend that you should already read this user guide. Fitting... -
Page 9: Chapter 2 ： About Ag19
Chapter 2 ： About AG19 Specification AG19 series PART NO AG19-00 AG19-10 AG19-20 (Relay only) (Reader only) (Relay + Reader) Standard Interface Wire – RS232 / RS485 / Wiegand Power Require AC / DC 9 – 12V ; 1A... -
Page 11: Dip Sw Setting
DIP SW Setting DIP1 DIP2 Approval Period 3 Seconds (Default) 5 Seconds 10 Seconds 15 Sconds DIP3 DIP4 Sensitivity of Alcohol Detection Very High (Default) High Middle... -
Page 12: Pin Description
Pin Description Name Description Vout Power Output to Reader (Reguralation 5V or Vin DC) Connect to Reader Wiegand D0 / RS232 TX / RS485+ Connect to Reader Wiegand D1 / RS232 RX / RS485- Connect to Host Wiegand D1 / RS232 RX / RS485- Connect to Host Wiegand D0 / RS232 TX / RS485+ Digital Output Digital Input... -
Page 13: Connection
Connection AG19-00 Relay onley... - Page 14 AG19-10 Reader only Power Control...
- Page 15 AG19-20 Relay + Reader...
-
Page 16: Chapter 4 ： Troubleshooting
Chapter 4 ： Troubleshooting 1. AG19 doesn’t work? Please check that the AG19 is actually connected to the power supply (AC / DC 9 – 12V ; 1A) . The red power light of AG19 is lighting... -
Page 17: Contact Us
Contact Us Address: 8F, NO.31, Lane 169, Kang-Ning Street, His-Chih Dist, New Taipei City, Taiwan Tel: 886-2-26954214 Fax: 886-2-26954213 Websites: www.gigatms.com.tw Email: Sales inquiry email - promag@gigatms.com.tw After sales service - support@gigatms.com.tw...