4. If you want to make a reconnection between two devices, Click RECONNECT Icon on Flash Programmer and Push the RESET SWITCH on Flash Writer. Do not pull out the USB Cable when TOSHIBA Flash Programmer is running. ON-BOARD WRITING Target Board 1. Install CP210x_Drivers.exe included on the CD-ROM 2.
OFF-BOARD WRITING 1. Connect one end of the USB cable to a USB Port on the PC 2. Connect the other end of the USB cable to the USB connector on the TOSHIBA MCU FLASH WRITER Figure 1. Hardware SETUP1 ON-BOARD WRITING 1.
TOSHIBA MCU FLASH WRITER INSTRUCTION MANUAL 4. Target Board Refer to Figure 3 for the detail information about the TOSHIBA MCU FLASH WRITER POWER SWITCH On-Board USB CONNECTOR Connector RESET SWITCH YAMAICHI SOCKET Figure 3. TOSHIBA MCU FLASH WRITER 4-1. Universal Serial Bus (USB) Interface (T1) A USB Connector is provided to facilitate connections to the USB interface on the FLASH WRITER See Table 1 for the USB pin definitions.
Page 5
TOSHIBA MCU FLASH WRITER INSTRUCTION MANUAL 4-2. On-Board Connector (T2) A On-Board Connector is provided to connections to the Target Board for On-Board Writing See Table 2 for the On-Board Connector pin definitions. Pin# Signal Description TEST Test pin for serial mode...