Outdoor South-American Style BBQ Cooking Wood Fire
Operating and Maintenance Instructions
Inbuilt Model
BBQ Model
Freestanding Model
IMPORTANT
Read all the instructions carefully before commencing the installation. Failure to follow these instructions may result in a fire hazard and void the warranty.
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
Page 1
Read all the instructions carefully before commencing the installation. Failure to follow these instructions may result in a fire hazard and void the warranty. Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
Extinguish the fire using a dry chemical household fire extinguisher, or smother it with loose soil or sand. OPERATING RULES Please adhere to Warmington’s rules of operation. Failing to do so may void the warranty of the appliance. • This appliance is a wood fire. Do not burn coal in the appliance. Burning coal creates excessive heat which the appliance is not designed for.
OPERATION The Warmington Kiwi Grill is an outdoor cooking appliance inspired by the South American style of cooking over hot coals or logs. The three models include: an inbuilt firebox (with flue system), a freestanding barbeque model and a freestanding pit fire model. The inbuilt and BBQ versions have a movable cooking grill as well as a removable warming rack.
ADJUSTING THE COOKING GRILL HEIGHT The height of the cooking grill is controlled by turning the wheel. On the inbuilt model, this wheel is on the front of the appliance. On the barbeque and freestanding models, the wheel is on the right hand side.
For the inbuilt model, the cams sit close to the middle of the shaft (as pictured below). For the BBQ and pit fire models, the cams sit close to the end of the shaft. For the inbuilt version, ideal cam location is such that when the grill is fully raised the wires are close to the centre point inline with the wire connection brackets on the grill.
Page 6
Pliers can be used to replace these crimps. The cams and wires should be set as per the schematic below. Note: this schematic is for the inbuilt model, however the BBQ and pit fire models follow the same principle. Note: the wires should always head inwards from the cams towards the centre of the shaft.
Does the flue exit at the recommended height and position? Additional draught can be attained by increasing the height of the flue (each additional metre of flue adds approximately an extra 10% of flue draught). Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification. All dimensions are in mm...