TT electronics S19A01 Quick Start Manual

Quick Start Guide
S-2CONNECT Hub S19A01
This is the quick start guide for S-2CONNECT Hub.
For the full user guide visit:
Introduction
Please read the full user guide
found on the website thoroughly
before bringing this device into
service.
Packet contents
• S-2CONNECT Hub
• Quick start guide
The power supply is provided
separately.
Switching the device on
This device switches on automatically following
charging of the battery.
The battery is fully charged when the charging LED
switches off. It may take up to 9 hours to charge a fully
discharged battery.
www.s-2connect.com
Installation and usage
1. Make sure there is no damage to the
equipment.
2. Choose your suitable installation location.
Consider the environmental requirements
and be advised that this device contains
antennas that could be affected from other
equipment within close range.
3. Connect the power supply
4. Check the LED's to verify proper operation
USB/Power
connector
Using the device
This device is intended for strictly remote operation. Log in to
your user interface to interact with the device.
Battery operation
This device is primarily battery operated, but the external power
supply can be continuously connected. The battery operation
time can be up to 12 months, dependent on configuration,
surrounding temperature and other parameters.
This symbol on the device or the
package means that all electronic
and electric equipment should not
be mixed with general household
waste.
Visit www.s-2connect.com/
documentation