Easydive leo3 Quick Start Manual

Right Hand Control
1. Autofocus (Exposure Reading) and Shutter Release Mode. To change the shooting
mode, hold down Button 1 until the Red LED is switched on (15 sec.).
2. Photo Shoot:
Mode 1: When you press the button you have the autofocus, when you release the
button you will have the shoot (Default Setting).
Mode 2: When you press the button first you have the autofocus and then the
shoot. (If the lens is already in focus you will have the direct shoot).
In Video Mode, starts or ends the Video Recording (REC).
3. This Button Starts or Ends the Video Recording (REC), also in Photo Mode.
The following buttons are enabled in Manual Mode (M). The mode selection must be
done before inserting the camera into the Housing. If you choose another mode, only
manually set functions are available. If you use the Camera in Video Mode, you will be
able to switch video modes.
4. Aperture -
5. Aperture +
6. Shutter Speed -
7. Shutter Speed +
8. ISO +
9. ISO -
10. On / Off electronic board (to switch on press once, to switch off hold down about
3 seconds until the board is switched off). The camera will go in Standby limiting the
power consumption.
With S1 and S1R, it is necessary to Remove the Rubber Protection of the Camera's Viewfinder,
to allow the correct closure of the housing.
Easydive - Via dell'Industria 13 int 6, 48015 Cervia (RA) - Italy
Press the buttons 4,5,6,7,8,9 once to change
by one step. Keep pressed to quickly change
the chosen parameter.
S1 | S1R | S1H | S5 | GH5s | GH5 | G9
Hand Control - Right
Front
info@easydive.it - +39 0544 962923 | +39 338 9994219
Back