Advertisement
OPERATION
• Grip the lamp housing press the Latch Button and rotate
Magnetic Base through 360° in the vertical and 110° hori-
zontally on the Swivel Ball (FIG 2).
• Place the base against any ferrous metal surface for mag-
netic attachment.
• Release Retractable Hook to hang from overhead objects.
• Depress and release round Button located at side of Housing
once for Low Brightness and a 2nd time for High (FIG 1).
• Depress Button once again to turn off.
CHARGING
• When the LED power indictor (FIG 1) located at the side of
the Housing glows RED, the battery requires charging.
- Flip up rubber seal and plug the Micro USB terminal
of the included Adapter Cord into the Micro USB port
(Fig 3).
- Plug the opposite USB end into the USB port of the
included Wall Charger or any suitable USB port (Fig 3).
- Plug wall unit into properly grounded 120 VAC,
60 Hz. outlet.
- Allow 4 hours for full charge.
- The indicator LED at the side of the Housing will illuminate RED while charging then
illuminate GREEN to indicate full charge (Fig 1).
- Close Charging Port Cover to maintain IP-65 rating.
Batteries will slowly discharge without use and must be charged every
3 months even if the light has not been used.
Do Not charge batteries in temperatures below 40°F [4.4°C].
CHARGING WHILE IN USE
The Lamp will default to the Low power setting while charging. The required charge time will be
extended if the lamp is operated when charging.
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: techelp@eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com
© Copyright 2018 Easthill Group, Inc.
PDF version of this manual is available at eastwood.com
FIG. 2
FIG. 3
7/18
Instruction item #32405Q
Rev 1
Advertisement
