PTRX-9700 INSTALLATION GUIDE
DISCLAIMER: We are not responsible for any damage to your radio during installation. Please operate at your
own risk.
You can access the latest version for this document at
This document has been prepared to guide you to install PTRX-9700 into your ICOM IC-9700 radio. This is solderless
operation, and you can remove PTRX-9700 from your radio at any time easily without any modification.
PTRX-9700 shipped with following items as shown in Figure.1:
1- PTRX-9700.
2- Fixture (non-conductive).
3- U.FL extensions.
4- Power cable.
5- Power adapter.
6- U.FL to SMA cable and SMA
fixture.
Installation Procedure
Before you start, you will need an 8mm wrench to replace the SMA connector and also a phillips head screwdriver
to remove the bottom cover of IC-9700.
1- Power off your IC-9700 and remove power cable.
2- Open the bottom cover of IC-9700 with a phillips head screwdriver.
3- Plug the power adapter as in Figure.2.
4- Detach U.FL cables from the PCB of IC-9700 then attach U.FL cables extensions to IC-9700 (VHFin, UHFin,
23in) as shown in Figure.3. Do not forget to attach original U.FL cables from IC-9700 to PTRX-9700.
5- Replace REF_IN SMA connector with supplied adapter as shown in Figure.4 (if you don't use REF_IN signal,
you can replace the SMA connector with supplied one) as in Figure.5.
6- Push PTRX-9700 on to the aluminum holder as in Figure.3, then attach the power cable to PTRX-9700.
7- Power your IC-9700 on and check if the green LED of PTRX-9700 is on as in Figure.6.
8- Close the bottom cover. Connect your SDR receiver to the RF output of PTRX-9700.
9- You are all set. Enjoy your PTRX-9700 panadapter!
Figure.2 : Power adapter connection.
www.radiospectral.com
www.radiospectral.com/ptrx-9700
Figure.1 : PTRX-9700 product content.
Figure.3 : Bypass cable connections.