Advertisement
Quick Links
Warning: Do not use with mount pipe longer than 18"
1. FIRST TIME ASSEMBLY: Attach adjustment knob using the square nut and nut clamp. Turn
base upside down. Place nut inside nut clamp and drop into slot on bottom of base so that the
open side of the nut clamp is toward the flat side of the base. Screw in adjustment knob. Use
this knob to remove and re-tighten pipe mount for travel or storage.
2. Attach compass to base, secure level to base.
3. Attach rubber feet to support legs.
4. Insert spring clips into the support legs until locked in place.
5. Slide legs into base until locked in place.
MODEL 3S-6016 TRIPOD/BASE MOUNT
Square Nut and Nut Clamp
Support Leg
Rubber Foot
Adjustment Knob
Bubble Level
Spring Clip
18in Pipe Mount
Compass
Base
Elastic Cord
Anchor Screw
Advertisement
Summary of Contents for 3S 6016
- Page 1 MODEL 3S-6016 TRIPOD/BASE MOUNT Warning: Do not use with mount pipe longer than 18" 1. FIRST TIME ASSEMBLY: Attach adjustment knob using the square nut and nut clamp. Turn base upside down. Place nut inside nut clamp and drop into slot on bottom of base so that the open side of the nut clamp is toward the flat side of the base.
- Page 2 OPERATION: 1. Turn satellite receiver on, and use installation menu to determine the azimuth and elevation for your location. 2. Remove the compass from the mount. The metal pipe and antenna will effect compass operation. Using the compass, determine the best location for the mount. NOTE: Satellite signals will not go through trees, buildings, etc.