Sonetics MiniHub SON114MH User Manual

MiniHub

FEATURES

™
Green LED Red LED Pair Button
Power Button
CHARGING & INSTALLATIONS
Wall Adapter Charging
Only charge the MiniHub using the supplied 12VDC regulated wall
adapter. Using unregulated wall adapters will damage the Base
Station charging circuit and components and void the warranty.
Vehicle Battery
RED to Battery+
1.5A Fuse
BLACK to Chassis Ground
Vehicle Charging
Note: Make fuse no further than 18" from the battery.
Note: Only replace fuse with the same type, 1.5A AGU.
1. The unterminated end of the supplied charging cable assembly and
fuse assembly must be wired to the vehicle per the diagram above.
2. Observe correct polarity when connecting the charger cable to
12V from the vehicle. Connect the RED wire to +12V and the
BLACK wire to battery chassis ground. This will result in a positive
center terminal of the charger jack as shown in the illustration.
BLACK RED
3. Charge MiniHub completely before use with 12V vehicle
power supply or supplied wall mount charger
.
4. For maximum battery shelf life, turn OFF the MiniHub.

BATTERY INDICATORS

LED Indicators: Charging Depleted Battery
20 Minutes
0%
No Light
(First 20 Minutes of Charging)
Charging Jack
Battery Level Indicator
Number of RED and GREEN Flashes at Turn ON
>
75%
50-75%
25-50%
<
25%
14
12
10
8
6
4
2
0
-60 -40
Up=PTT On
C
2 Hours
100%
Flashing Red Steady Green
(While Charging) (Fully Charged)
Up=PTT On
C
Battery Life vs Temperature
-20 0 20 40 60
Degrees Centigrade
Up=PTT On
C
P A I R I N G
A
Press and hold the pairing button while turning on power to
the MiniHub. After 5 seconds the green and red LEDs will start
flashing in a fast alternating pattern. Release the pairing
button.
B
To pair to the MiniHub; hold PTT button down on the Headset
(on Toggle Headsets; hold toggle switch up) and then turn
power ON. When both Red/Green Headset LEDs are alternating,
release the PTT button (on Toggle Headsets; release toggle
switch). The Headset will connect to MiniHub within 30 seconds.
Headset with
Toggle Switch
Toggle Up
Headset with
PTT Button
PTT Button
C
When the Headset Green LED remains steadily ON the
headset is successfully paired to the MiniHub. If the Headset
Green LED flashes rapidly then repeat the pairing procedure.
Paired
80
W
Power On
Power On
Not Paired