Advertisement
1. Turn the remote control on by moving the switch on the remote to volume ( ) or mute (
The T-Rex sounds will come from the speaker on the remote control.
NOTE: While in mute, the T-Rex will function as normal but the sounds will be o .
2. Move the switch behind the T-Rex's back armor to the ON position (Fig. 2).
O
FIG. 1
1. Place the T-Rex on a at surface.
2. Follow the remote guide below to move your T-Rex. Your T-Rex's tail swings side-to-side when it moves.
3. Run into small objects to watch your T-Rex chop down on them. There is a button on the T-Rex's
bottom mouth (Fig. 3). Once an object hits the button, its mouth will close. Press the up button on the remote
control to move the T-Rex forward and the mouth will open up again.
Press the up button to make your
T-Rex move forward. (Press the down
button and it will go in reverse.)
Press the T-Rex button in the middle to see your
T-Rex 1) Rotate in a circle or 2) Move from left to
right while making chomping sounds. Note:
2
Move remote switch to the volume on position
to hear sounds ( ).
QUICK START
)(Fig. 1).
OFF ON
FIG. 2
LET'S PLAY
Press the left button and the T-Rex
will turn to the left. Press the right
button and it will turn to the right.
Press and hold the button and your
T-Rex will spin in that direction.
Run into objects and the mouth will close.
Press the up button on the remote control to
open its mouth again.
• Do not play with T-Rex Strike RC in the street or where there is vehicular tra c or in heavily traveled areas with
pedestrians.
• Do not stand on, sit on or throw T-Rex Strike RC, as doing so can result in injury to the person and irreversible
damage to the unit.
• Do not run T-Rex into furniture, walls, pets, people etc., as doing so may cause injury to the person and pets and
irreparable damage to the unit.
• Do not allow long hair or loose apparel such as shoestrings near the turning wheels of the T-Rex.
• Keep hands and ngers away from the T-Rex's mouth.
• Do not drive T-Rex through water, mud, etc.
• Keep the remote control in range to operate the T-Rex correctly.
• If the T-Rex stops working properly or doesn't work as it should, turn o remote and T-Rex and then turn it back on. If
there is still a problem, replace the batteries.
• Turn o the remote control and the T-Rex after use to conserve battery power.
• Frequency band range is 2.400GHz - 2.483GHz.
• Maximum radio-frequency power is 3dBm.
• For best results, use on at, hard surface.
FIG. 3
IMPORTANT INFORMATION
3
Advertisement
