Demo Mode - Honda ACCORD 2008 Manual

INTERACTIVE NETWORK
Export
Select this button to move the customer's data from the original navigation unit to the PC card. Select YES on the Export User Data Confirmation screen. The process takes
only a couple of seconds. The system stores two files on the card.
Import
After installing the customer's original DVD in the new navigation control unit, allow the system to boot up. Insert the PC card in the new navigation control unit and enter the
navigation diagnostic mode.
Select YES on the Import Confirmation screen.
Import moves the two files stored by the Export process from the PC card to the new navigation unit. When the transfer is finished (a few seconds) the system will
automatically reboot. After the system reboots, remove the PC card from the PC slot.
If the Import button is grayed out, follow the troubleshooting in the FAQs below. The customer's files can only be transferred to a new navigation control unit if the Model and
the Program Flash shown on the Version screen are the same. These files cannot be transferred from an Accord to a Civic, or from an Accord with version 1.07.00 to a
another Accord with version 1.32.00.

Demo Mode

This screen is for factory use only, and should always be set to OFF. Occasionally the DEMO setting is turned ON when vehicles are being used at Auto Shows or similar
events. Turning this feature on, allows the navigation system to automatically follow a route to a destination when the vehicle is stationary. The Speed changes the speed of
the demo mode.
American Honda Motor Co., Inc. Page 12 of 20