Square Getting Started Manual page 4

SECURE SQUARE STAND TO YOUR COUNTER (OPTIONAL)
For extra security, you can mount Square Stand to your counter by using one of the following methods.
Option 1: Drill mount (recommended)
You need a drill and the following items from the included toolkit: drill bit, thumbscrew and thumb nut.
Use the included drill bit to make
1 Mark the spot on your counter 2
a hole in your counter.
where you want to secure Square
Stand. Note: Maximum counter
thickness is 44 mm (1.75 inches).
Option 2: Adhesive mount
You need the included adhesive plate.
1 Using a damp cloth, clean the area 2 Screw the adhesive plate into
where you want to secure Square the base of the stand.
Stand. Wait for the surface to dry
completely.
Line up the hole in the base of With the thumb nut on the
3 4
Square Stand with the hole in thumbscrew, carefully insert the
the counter. screw and tighten from the bottom
until the thumb nut is flush against
your counter.
3 With the base of Square Stand in 4 Adhere the stand to your counter
the locked position, remove the in the desired position and press
paper backing from the adhesive down firmly for 30 seconds. Wait
plate. Note: The plate is extremely 30 minutes for the adhesive to set.
adhesive and difficult to remove
once placed.
HOW TO TAKE A PAYMENT
Tap Insert
In the Square app, tap Charge and wait for a single In the Square app, tap Charge and wait for a single
green light to appear on Square Reader. Your green light to appear on the reader. Your customer
customer can then hold a contactless card or can then insert a chip card and enter the PIN on your
device near the reader to trigger payment. Square Stand. Leave the card inserted until four green
lights appear on Square Reader.
Need help? Get the full guide at square.ca/taking-payments.
Swipe
In the Square app, tap Charge. Run your customer's
magnetic-stripe card through the magstripe reader on
Square Stand.