Advertisement
4. ASSEMBLY
Assembly will require two persons. The central column will be
partially assembled with a tube fully inserted against the forces of
an internal compression spring. ▲It is important to leave this
tube inserted and pinned as supplied at this stage.
4.1.
Offer the three tripod legs (item 5) into the central column
pockets (item 1).
4.2.
Fit loosely the three cross members (item 5) to the tripod
legs with fixings (items 7,9,10,11)
4.3.
Fit loosely the three brackets (item 6) to the tripod legs
with fixings (items 8,9,10,11) and the central column ring
with fixings (items 7,9,10,11).
4.4.
Tighten all fixings to form a rigid geometrically aligned
frame.
Safety
Pin
Rotate for height
fine adjustment
75mm end stop
to end stop
5. OPERATION
5.1.
It is the responsibility of the owner to ensure that the operator has read these instructions together with the safety features on the side
of the stand and that the operator is familiar with the stands use and limitations.
5.1.2. Elevate the vehicle to the required working height and position a minimum of four stands with appropriate saddles beneath the vehicle
manufacturer's recommended jacking/support positions.
5.1.3. For large movement of the the column tube it will be necessary to retain it by hand whilst withdrawing the height setting pin. Allow the
column tube to elevate assisted by the spring to the nearest available pin hole prior to engaging with the vehicle. Ensure the pin is
inserted fully and safety pinned, then rotate the fine adjuster to close the gap to zero at all locations.
5.1.4. With all stands stable, slowly lower the vehicle to be fully supported by the vehicle stand.
6. MAINTENANCE
6.1.
Before each use or after an abnormal load or shock, check that stands and stand welds are not cracked and that there are no missing
or damaged parts, including fixings. Any suspect axle stands must be removed from service immediately. An annual inspection of the
unit is recommended to be carried out by the supplier's authorised repair facility.
6.2.
Periodically lubricate the fine adjuster thread with a light general purpose oil.
6.3.
After use, wipe clean the stand and saddles, return the saddles to the storage ledge. Store indoors.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Retain the sprung loaded tube
when removing the variable
height setting pin.
Variable height
setting pin
75mm steps.
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
1
7,9,10,11
4
01284 757500
01284 703534
2a, 2b, 2c
8,9,10,11
3
6
7,9,10,11
5
www.sealey.co.uk
W e b
sales@sealey.co.uk
email
ASC70 Issue: 1 - 01/12/15
Advertisement
