Product Dimension Drawing; Usage Method - Hisense IdeaHub Series User Manual

Product Dimension Drawing

Usage Method

[Description]
• After the OPS-C module is installed, OPS-C is used as the touch host by default
for the touch screen of the whole machine. When the side touch is connected to the
external computer, the external computer is used as the touch host. At this time, the
display channel from the signal source to the external computer should be switched
for touch.
OPS-C Switch
You have selected and installed OPS-C module. If the power is turned on in the
whiteboard channel or another channel switches to the whiteboard channel, OPS-C
module will start automatically.
[Description]
• Powering off the Team Collaboration Board directly will damage the hard disk of
OPS-C module. It is strongly recommended that you use the following two methods to
power off:
1. When the Team Collaboration Board is turned off, use the standby key of the
remote control or the shutdown key of the Team Collaboration Board. At this time, the
OPS-C module will shut down normally, and then cut off the power supply.
2. Close OPS-C manually and use the computer's own start menu.
• After the OPS-C is shut down illegally due to the direct power failure of Team
Collaboration Board, the windows repair interface will appear. At this time, the touch
screen will fail. Only USB keyboard or wireless keyboard can be used to confirm the
repair. After the repair is completed, the system will continue to enter.
OPS-C Settings
For the new OPS-C module, you need to enter BIOS to set the module. During the
OPS-C power on process, enter the BIOS option according to the prompt. In advanced