SportCrafters ROLLERS Manual

 Always wipe the roller down after use to avoid corrosion.

Use a damp cloth only; do not use any cleaners.

 Always disengage the belt or fold the unit after use.

Leaving the belt stretched between the drums for long

periods of time will cause the belt to lose tension.

 The bearings are permanently lubricated and sealed, and

they do not require maintenance.

 Make sure all fasteners are snug. Do not over-tighten any

fasteners as it can damage the roller frame.

 PVC Rollers Only: The drums may warp if exposed to

direct sunlight or excessive heat for extended periods.

SportCrafters warrants all products to be free of any and all

defects in material or workmanship. This warranty does not

apply to parts that have excessive wear due to normal use,

misuse, neglect, accident, or acts of God. Where applicable,

incidental and consequential damages are not covered, and

there are no other warranties, expressed or implied. This

warranty applies to the original owner, and is valid for a lifetime.

Please retain your receipt as proof of purchase.

In the event of a warranty, please contact us at

info@sportcrafters.com, or call 574-243-2453.

51345 Bittersweet Road

Granger, Indiana 46530 USA

Table of Contents

Need help?

Do you have a question about the ROLLERS and is the answer not in the manual?

Page 1  Make sure all fasteners are snug. Do not over-tighten any fasteners as it can damage the roller frame.  PVC Rollers Only: The drums may warp if exposed to direct sunlight or excessive heat for extended periods. SportCrafters warrants all products to be free of any and all defects in material or workmanship.
Page 2 We are If your roller drums are assembled with nuts, use two 9/16” proud to be the largest U.S. manufacturer of rollers, and we wrenches, or 14mm wrenches, holding one nut inside the rail believe wholeheartedly in the positive results they render.
Page 3  To disable the progressive resistance, and use the roller for easier spinning at higher speeds, simply reverse and install with the red cap on the left while riding the rollers. Important Note: Feedback we have received from various users tells us that many stronger athletes like the ability to do intense climbing intervals by pushing hard at low cadence.
Page 4  Make sure the rollers are on a flat surface. Carpet can models is not guaranteed. interfere with the rollers.  Start out by placing the rollers in a hallway or a doorway. Follow instructions provided with your roller to adjust the...