Download
Share
Print this page
Sliger CL520 Manual
  1. Manuals
  2. Brands
  3. Sliger Manuals
  4. Computer Hardware
  5. CL520
  6. Manual

Sliger CL520 Manual

Console style mini-itx pc case for 2-slot gpu
Hide thumbs

Advertisement

Quick Links

Download this manual
CL520
Console Style Mini-ITX PC Case for 2-slot GPU

Advertisement

loading
Need help?

Need help?

Do you have a question about the CL520 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sliger CL520

  • Page 1 CL520 Console Style Mini-ITX PC Case for 2-slot GPU...
  • Page 2 SCREWS The CL520 comes with a total of 7 different screws. For the purpose of this guide we will assign a unique color to each of the screws, signifying their locations within the case. CYAN M4 .7 x 5mm FLAT HEAD...
  • Page 3 TOOL-LESS TOP PANEL The CL520 top features tool-less removal via ball-stud mounting points. Grasp the lip on the rear of the cover panel and pull upward to remove. The front ball studs may require altering the angle you are pulling from to release.
  • Page 4 Some CPU coolers may require a back plate installed before installing the motherboard. It is advised for the CL520 to also check that any M.2 mounts on the back of motherboard have drives installed before installation of the motherboard, as there are no SSD or HDD mounting points inside the case.

  • Page 5: Power Supply

    POWER SUPPLY Remember to connect all required modular power cables FIRST The power supply should be positioned with the fan side towards the top of the case. This orientation will result in better overall system temperatures and lower noise. Once positioned, the SFX PSU can be attached to the PSU Mounting Bracket with up to 4x 6-32 x 1/4”...
  • Page 6 INSTALLING CASE FANS Use 4x M3 x 12mm FLAT HEAD screws to attach the fan guard. Place fans into chassis sliding in the BLUE fan studs. Follow the proper orientation of the fan guard in photo below and the fans MUST exhaust air out of the case.
  • Page 7 GPU MOUNTING The process of installing the GPU is same as it would be on a standard case setup, just on a PCIe riser. Slide the card into position, push down into the slot, and then secure the PCIe card bracket with M3 x 6mm PAN HEAD screws.

  • Page 8: Power Cord

    PSU. NOTE: The CL520 Pigtail option is to increase max GPU card height to 157mm where as the standard option only allows for a card height of 133mm.

  • Page 9: Cable Management

    CABLE MANAGEMENT The power switch/LED is routed and plugged into the motherboard. The power cord is mounted above PCIe Slots and properly screwed to the cover plate or passed through the grommet, and routed to the inlet on the power supply if using the pig tail configuration.
  • Page 10 CASE HANDLE The Case Handle is attached with 2x M4 x 12mm SOCKET CAP. Use the included Allen key to tighten. NOTE: Do not over-torque screws...

  • Page 11: Base Plate

    BASE PLATE Base plate is attached with 2x M4 .7 x 5mm FLAT HEAD Along with optional 4 rubber feet that can applied to the corners. NOTE: Slot cut-out goes under PCIe Slots. Do not over-torque screws...