Brother BE-0901E Quick Reference

BE-101,916,901,1216,1201 Quick Ref.
LOADING A DESIGN FROM A FLOPPY DISK
Insert floppy disk into the disk drive
Press the "Floppy Disk" button to enter machine
memory selection screen
Press the "Floppy Disk" button to enter floppy
disk selection screen
Press the "Arrow Keys" to move the highlighted
area over the design you wish to load.
Press the "Needle Select" buttons to
change pages.
Press the "Start" button to copy the design to the
machine memory and make it the active design.
Note: Machine will not start. You would
have to press "Start" again before the
machine would start sewing.
SETTING THE COLOR SEQUENCE
Press the "Needle Set" button to enter the color
programming mode
Use the "Numeric Keypad" to assign a needle
number (Color).
Use the "Zero" button to assign a
two-digit needle. (example: 12)
Continue to select needle numbers until all colors
have been programmed.
Press the "End" button to exit the color-
programming mode with the sequence saved.
For Technical Assistance Please Call Toll Free 1-877-4BROTHER
.
.
POSITIONING AND SEWING THE DESIGN
Press the "Arrow Keys" to center your design in
the hoop.
Press the "Confirm" button to verify the design
will fit in the frame at the location you have chosen.
Use the "Numeric Keypad" to assign a sewing
speed by pressing a number 1–6. 1=fast, 6=slow.
Press the "START" button to begin sewing the
design.
ENTER A DESIGN FROM THE MACHINE MEMORY
Press the "Floppy Disk" button to enter machine
memory selection screen
Press the "Arrow Keys" to move the highlighted
area over design you wish to load.
Press the "Enter" button to select the design for
sewing.
Set the color sequence for the design.
Position and Sew the design
ROTATE A DESIGN
Press the "Edit" button to enter the design edit
mode.
Press the "Left & Right Arrow" buttons to
change the degree at which to rotate the design.
Press the "End" button to save the rotation degree
and exit the edit mode.
1
.