Download Print this page

Sigma Prosight2 Fittings Manual

For meyer leopard

Table of Contents

Download this manual

Mounting Kit for Meyer LEOPARD

Thank you for purchasing the Mounting Kit for fitting the Prosight2 sender

unit to a Meyer LEOPARD line array bumper. Each kit comprises two

brackets for two arrays.

Follow the simple instructions over the page to attach sender units to the

bumper and remember to reset the angle for each one on the Prosight2

Meter unit before flying the arrays.

The full procedure for operating the units and setting angles is explained in

the Prosight2 User Guide.

Kit contents

Each mounting kit comprises:

2 x LEOPARD single piece steel brackets

2 x Prosight2 safety cords

4 x M4 8mm screws

8 x M4 1mm rubber washers

8 x M6 25mm countersunk set screws

1 x LEOPARD Fitting Guide

Prosight2 from Sigma Products

FITTING GUIDE

P/N: 0300-0004-0001 V2.2

IMPORTANT: To ensure the IP rating of the Prosight2

sender, use the rubber washers (provided) when

mounting the sender to the bracket

www.prosight2.co.uk | 1

Table of Contents

Do you have a question about the Prosight2 and is the answer not in the manual?

Page 1 Follow the simple instructions over the page to attach sender units to the bumper and remember to reset the angle for each one on the Prosight2 Meter unit before flying the arrays. The full procedure for operating the units and setting angles is explained in the Prosight2 User Guide.
Page 2 Sender unit onto the bumper so it aligns with the four screw holes and the laser will fire through the hole in the front of the bumper. 2 | Prosight2 from Sigma Products www.prosight2.co.uk...
Page 3 8) Reset the angle of sender unit Attach the bumper to the first cabinet in the array and with the cabinet level, reset the angle so the Meter displays 0.0° (see User Guide for full information). Prosight2 from Sigma Products www.prosight2.co.uk | 3...
Page 4 Important Safety Information ▪ Ensure all nuts and bolts are tight before flying the array. ▪ The safety cord must be securely attached to the Prosight2 Sender unit and the bumper at all times. ▪ When lifting the array, ensure that the ethercon cable is free to move and does not foul the cabinet or the rigging shackles.