Getting Started - VTech Baby Roar & Explore Wheel Parents' Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back of the
steering wheel. Use a screwdriver to loosen
the screw and then open the battery cover.
3. Remove old batteries by pulling up on
one side of each battery.
4. Install 2 new AAA batteries following the
diagram inside the battery box.
5. Replace the battery cover and tighten
the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries or fully charged NI-MH (Nickel Metal-
hydride) rechargeable batteries for best performance.
• Use only batteries of the same or equivalent type as
recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc), rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity (+ and -).
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
5