Hobbytech Spirit NXT Evo 4S Instruction Manual page 6

EVEN IF THIS CAR IS A READY TO RUN KIT, YOU STILL HAVE SOME LITTLE THINGS TO DO TO FAMILIARI ZE WITH YOUR
PRODUCT.
PLEASE FOLLOW THESE STEPS.
Functions
KT2S+ Transmitter
Steering Wheel : Control direction (Left / Right) of the RC
Throttle Trigger : Control speed and direction (Forwar-
Battery Compartment Tray : Cover and hold the batteries powering the
Antenna : Transmit signal to the model
Power ON / OFF : Power ON / OFF the transmitter
SYNC & Battery Indicator : Top Green LED light indicates synchroni-
ST. Trim Dial : Adjust the neutral position of steering
TH. Trim Dial : Make sure the model stays still when
WARNING: accidental or intentional EPA function manipulation
may cause servos malfunction (reduced or inexistant travel).
Please reset maximum default values before contacting your
dealer (see «EPA», on page 7).
Battery Installation
Works with 4 x 1.5V AA
Batteries (not provided),
KT2S+ can be operated a
few hours. Installation:
Remove the battery
compartment cover as
shown below.
Warning: Never disassemble batteries or put the batteries in fire, chemical
agents, otherwise they may cause personal injuries or property damages.
Battery Disposal: Observe corresponding regulations about wasted battery
treatment regulations.
1. After running out of power, dispose of wasted batteries in designated
areas far away from water supply, household areas and planted areas.
2. Submit the wasted batteries to specific recycling stations.
6
TRANSMITTER
model.
d/Brake/Backward) of the driving model.
transmitter.
zation status
and/or adequate battery power supply.
ATV : Adjustable Steering Rate by ATV dial
servo when model wheels are straight
ahead.
releasing the throttle trigger.
EPA : End Point Adjustment
Install the batteries Then reicompart-
observing the polarity ment cover as the
marked on battery picture shown
compartment. below.
ATV
Power Indicator
Power
ON / OFF
Steering
Reverse Switch
Throttle
Reverse Switch
Steering Trim Dial
Throttle Trim Dial
Battery
Compartment Tray
Battery LED Indicator
- During normal operation, the LED should be solid green ON-
- When battery voltage is dropped below 3.8V, the LED will become red
color and flashing very slowly, to indicate battery is low, you should replace
new battery as soon as possible
Pre-Run Check
LED
LED
Indicator indicator
* Always turn on the transmitter first by sliding the switch on the left side
from bottom to top. The green lights above the switch should light up. If not,
you need to check for low or incorrectly installed batteries.
Antenna
Steering Wheel
Throttle Trigger
BIND / EPA Key
1. Steering : Adjust the steering trim to
keep the front wheels in straight line
when steering wheel remains in
NEUTRAL position.
2. Throttle : Adjust the throttle trim to
ensure the wheels stop rotating when
throttle trigger remains in NEUTRAL
position (only for nitro).
For EP vehicles, this button must be
set to NEUTRAL (See «1- The neutral
point on page 9).