AUT-WT1
AUTOMATIC TOUCH ON/OFF
AUT-WTM2
AUTOMATIC METERED TOUCH
AUT-WP3
AUTOMATIC TOUCHFREE
AUT-WPM4
AUTOMATIC METERED TOUCHFREE
Features:
•
Can be used with most Watermark wall mount spouts and finishes
•
No visible sensor – turns the spout itself into the sensor
•
Battery operated – no need for hardwiring
•
Safety timeout so water doesn't run indefinitely (WT1 and WP3 only)
•
Metered option to satisfy local codes for public bathrooms
•
No temperature control – water should be pre-tempered
Specifications:
•
Working water pressure: 20 PSI to 85 PSI
•
Working water temperature: 45°F to 120°F
•
Working environmental temperature: 35°F to 100°F
•
Flow Rate: 1.2 GPM
•
IP55 water and dust protection
•
6V CR-P2 lithium battery (included)
•
12 second metering cycle (WTM2 and WPM4 only) provides 0.24 gallons per cycle
•
Shipping weight (lbs.): 10
•
Shipping dimension (in.): 29 x 12 x 4
Note:
•
DO NOT USE PLUMBER'S PUTTY ON ANY OF THE BRASS COMPONENTS
This will cause the finish to tarnish and void the warranty. A non-corrosive Alkoxy Silicone is
recommended.
•
DURING SWEATING OF LINES DO NOT OVERHEAT CASTING
Overheating may cause damage to internal mechanism and void the manufacturer's warranty as well
as increase the risk of scalding.
•
COPPER ADAPTORS MAY BE REQUIRED TO COMPLETE YOUR INSTALLATION
•
Not for use with metallic sinks or counters.
Diagram A - Dimensions
WALL MOUNT AUTOMATIC FAUCET
INSTALLATION FOR
P a g e
Rev. 2/20
| 1