Toro Power Max 115-5699 Installation Instructions Manual

Drive Shield Kit
Power Max
Model No. 115-5699
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Removing the Belt Covers and
Cleaning the Snowthrower
Frame
No Parts Required
Procedure
1. Remove the 4 bolts that hold the belt covers in place,
and remove the belt covers.
Note: Save the screws to install the belt cover.
2. Clean and dry the top of the snowthrower frame to
remove all oil and dirt.
Important: The sealant will not adhere to a
dirty frame, and an improper seal may allow
moisture to penetrate the seal and leak onto the
friction wheel.
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® Snowthrowers
Description
No parts required
Drive shield
Bolt
Trim seal
Register at www.Toro.com.
Qty.
–
1
Install the drive shield.
2
1 Install the trim seal.
2
Installing the Drive Shield
Parts needed for this procedure:
1 Drive shield
2 Bolt
Procedure
Important: You will need a flexible silicone RTV
sealant (such as Loctite 5045 or Loctite 5905) to
complete this procedure. The sealant should be
water and oil resistant.
1. Apply 2 parallel beads of sealant to the bottom of
the drive shield (Figure 1).
Note: Do not apply sealant in the area between the
locating tabs and the front edge of the drive shield
(Figure 1).
Form No. 3361-375 Rev A
Installation Instructions
Use
Original Instructions (EN)
Printed in the USA
All Rights Reserved