IntelliSense ST900C User Manual Addendum

1.

Introduction

This Addendum is intended to cover the addition and operation of remote 5804H wire-free Keyfobs
when connected to the ST900C control panel. The Keyfobs maybe connected to either a 5882H
receiver or 6128RFH LCD Keypad. Your Alarm Company will inform you if this addendum is
applicable to your system. This addendum should also be read in conjunction with the ST900C user
manual and 6128RFH LCD Keypad (if fitted) user instructions.
2.

Remote Keyfobs

The system can support up to eight separate Keyfobs for setting and unsetting only. The Keyfobs are
assigned to the system as user numbers (eg Keyfob 2 = user 2). A combination of user codes and
Keyfobs may be used.

To Add a New Keyfob

1. Enter Master Code (eg 1234).
2. Press key 8.
3. Press a user number (pick a user number from 1 to 8).
4. Wait for a double beep.
5. If receiver is the 5882H, press and hold all four keys on the Keyfob until a double beep is heard
then release the keys.
6. If receiver is the 6128RFH LCD Keypad, press and hold any three keys on the Keyfob until a
double beep is heard then release the keys.
1. Press and hold any one key on the Keyfob until a double beep is heard.
Note: If a triple beep is heard at any point, the procedure has failed. Wait ten seconds and try again.
Perhaps the Keyfob is already programmed to another user.

To Delete a Keyfob

2. Enter Master Code (eg 1234).
3. Press key 8.
4. Press the user number the Keyfob belongs to (1 to 8).
5. To delete the user code and Keyfob press *.
6. To delete the Keyfob only, wait for a double beep then press *.
Note: The Master code (user 1) cannot be deleted but a Keyfob assigned to the Master code can be
deleted. Keyfobs can be used to Full set, Part set and Night set the system. They can also be used to
unset the system. However, they cannot reset an alarm condition, as this requires viewing of the
Keypad display.
ST900C
User Manual Addendum