Panasonic TH-P65VT50A Service Manual page 30

9.2.23. Remove the M8 nut metals
1. Remove the screws (×2
metals.
9.2.24. Remove the Contact metal bottom
B
1. Remove the screws (×8
2. Remove the Contact metal bottom B.
9.2.25. Remove the K-Board
1. Remove the screw (×1
2. Disconnect the connector (K1) and remove the K-Board
from the LED panel.
9.2.26. Remove the Cabinet assy from the
Plasma panel section.
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
each) and remove the M8 nut
).
).
2. Remove the screws (×14
3. Remove the Plasma panel section from the Cabinet assy.
9.2.27. Remove the Contact metals
1. Remove the Tape from the Contact metals.
2. Remove the screws (×10
3. Remove the Contact metal side (L, R).
4. Remove the screws (×15
5. Remove the Contact metal bottom A.
9.2.28. Remove the C1-Board
1. Disconnect the flexible cables (CB1, CB2 and CB3).
2. Disconnect the flexible cable (C10).
3. Disconnect the connector (C14).
4. Remove the screws (×3
30
).
).
).
) and remove the C1-Board.