Nabco Acusensor 3 Quick Setup

CAUTION: All adjustments
and final door operation must
conform to ANSI 156.10
"Quick Set-Up" General Wiring and Settings for Acusensor 3
DN 0343.5
Under normal circumstances the medium setting should be used. When adequate

Sensitivity setting

detection cannot be achieved, use a higher sensitivity. If the Acusensor 3 activates
unnecessarily, use the lower sensitivity.
Presence Timer determines the time need-
ed by the sensor to learn an area, or relearn
changes within that area.
Ph: (877) 622-2694 Fax: (888) 679-3319 Web: www.NabcoEntrances.com
For greater details, see the Acusensor 3 Manual (P.N. 15-8911-3)
Acusensor Harness P/N 22-9184
Sensors placed close to each other
should be set to different Interference
Prevention Settings.
Nabco Entrances Inc. S82 W18717 Gemini Drive, Muskego, WI 53150
Black
Power Supply 12 to 24V AC / DC
Red
White
Form A relay Output, 50V 0.1A Max. (Resistance Load)
Green
Page 1 of 3
P/N 15-13943 Rev. 8-30-12
CAUTION: This Sensor Cannot
be used for Presence Detection
on the Pull Side of Swing door.
Snow mode is only active when the
temperature is at, or below 41°F (5°C)
Level 3 has the highest immunity