Table of Contents
Advertisement
Available languages
Available languages
•
Before connecting the low-pressure regulator, please check and read the following: The gas
heater should only be powered by Propane-Butane in a container with a maximum weight
of 15kg. Connect the low-pressure regulator with a fixed calibration that complies with
EN16129. The hose should be according to national standards. For correct connection, the
hose should be connected using hose clamps of a suitable size. For correct connection, fol-
low the instructions provided with the low-pressure regulator.
•
Slide the two metal rings around the hose. Connect the hose to the hose union of the
low-pressure regulator and to that of the tab. Close the metal rings firmly with a screw, but
make sure that you do not damage the fitting or any component.
•
Before connecting the low-pressure regulator to the gas container, make sure that the gas
container is closed and that there are no open flames (i.e. a lit oven) in the place where you
are working. Connect the low-pressure regulator according to the user instructions that are
provided with the low-pressure regulator.
Check for gas leaks: see section "gas leaks"
In addition
•
To replace the gas container, make sure that the gas container is closed (follow the user
instructions provided with the low-pressure regulator). Let the gas heater cool down first
and make sure that there are no open flames or other sources of heat in the area in which
you are working.
•
In addition it is recommended that the gasket seals of the regulator and the flexible rubber
hose be checked to ascertain their condition. If you have any doubt concerning the condi-
tion of the hose or the seals, replace them.
•
Make sure that you do not damage the connection or any other components;
•
Never turn the gas container upside down in order to make full use of the contents. This
may release liquid residues left in the container that damage the heater irreparably;
•
For disconnection or connection of the low-pressure regulator, always follow the user
instructions provided with the regulator;
•
The manufacturer is not responsible for any harm or damage if attention is not paid to the
points described above.
INSTALLATION
Top view
4
32
min 1500 mm
Advertisement
Table of Contents
