Date: 2011-12-29 Page: 3 av 17 General Westerstrand time- and temperature displays, alternates time and temperature in 1-25 seconds intervals. This device is for use alternatively as digital clock or as chronometer. 7-segments LED digits in dimensions 150, 190, 250, 300 and 450 mm.
When the clock is installed permanently, a readily accessible disconnect device (2-polar, 3 mm contact gap) shall be incorporated in the fixed wiring. Set correct time and date according to the programming instructions on page 10. WESTERSTRAND URFABRIK AB Box 133 Tel. 0506 48 000 Internet:: www.westerstrand.se...
TC and MIN-imp is connected at +IMP and –IMP. +IMP -IMP DCF 2-wire is connected V+ and – (GND) V+ - +IMP -IMP DCF RECEIVER T/T LED DCF 3-wire is connected DCF , V+ and – (GND) GND + +IMP -IMP DCF RECEIVER T/T LED WESTERSTRAND URFABRIK AB Box 133 Tel.
Set the straps according to the strapping schema page 6. Connect the TC wires, see page 5. Set the T/T in synchronisation mode sync. Functions DCF see programming page 10. After one correct accepted time message the time is displayed and the colon starts flashing on and off.
1 red. 2 black 3 Screen TEMP.SENSOR Programming Programming is made via a remote control or push buttons at the computer board. WESTERSTRAND URFABRIK AB Box 133 Tel. 0506 48 000 Internet:: www.westerstrand.se 545 23 TÖREBODA Fax. 0506 48 051 E-mail: info@westerstrand.se...
1 (weakest), 50 (strongest) (the Other level). Push [P] for desired light intensity. Accept with [F]. Display shows Sy nc Push [R] for entering base mode or push [F] for next function. WESTERSTRAND URFABRIK AB Box 133 Tel. 0506 48 000 Internet:: www.westerstrand.se 545 23 TÖREBODA...
Push [P] for desired correction value ( 9 ˚C). Accept with [F]. Push [R] for entering base mode or push [F] for next function. Setting DLS-function. With this function the DLS can be activated. Push [F] until display shows. WESTERSTRAND URFABRIK AB Box 133 Tel. 0506 48 000 Internet:: www.westerstrand.se 545 23 TÖREBODA...
Time can be counted up or down. At the end of the count period a buzzer signal is heard. The buzzer signal time is adjustable from 0-9 seconds. The buzzer can also be shut off manually. There is an output for an external relay. The relay is a factory mounted option. WESTERSTRAND URFABRIK AB Box 133 Tel. 0506 48 000 Internet:: www.westerstrand.se...
If the unit is set to show hours "HH:00" is displayed. If not programming starts with minutes, see below. Press [] and [] until selected hour is shown. Accept with [YES]. Display shows "nn:05". WESTERSTRAND URFABRIK AB Box 133 Tel. 0506 48 000 Internet:: www.westerstrand.se...
Before starting the display shows 1:00:00. After pushing the start button the display shows 59:59:99. The display now shows hundreds of a second. After 59 minutes the display will show 01:00:00. Example static display. WESTERSTRAND URFABRIK AB Box 133 Tel. 0506 48 000 Internet:: www.westerstrand.se...
Need help?
Do you have a question about the T/T and is the answer not in the manual?
Questions and answers