Advertisement
4.4.
Remove Drawers (refer to fig.3).
4.1.1. Pull drawer out until it is almost fully extended. Push up one black release lever, while pulling down the other hand black release
lever.
4.1.2. Whilst holding the levers in these positions pull the drawer out until it is released from the drawer slide.
4.5.
Replace Drawers
4.5.1. Extend the drawer slides from the tool chest/cabinet.
4.5.2. Insert the brackets on each side of the drawer into the slots in the chest/cabinet slides, being careful that they are properly positioned.
4.5.3. Once properly inserted, completely close the drawer to set the slides in their proper positions.
4.6.
Raise and Release Drawer Fronts (refer to fig.4)
4.6.1. These units are equipped with raise and release drawer fronts.
4.6.2. To open, lift up the drawer front, whilst pulling it towards you. To close, shut the drawer firmly, until the latch engages.
4.6.3. If the drawer does not stay closed, the hook may be bent or it may rub against the drawer slides. To fix lightly bend the hook until the
drawer will engage in the slide.
4.7.
Chest and Cabinet Connection PTB104008SS PTB10511SS (refer to fig.5)
4.7.1. Take out the work top from on top of the rollcab.
4.7.2. Place the chest on the rollcab.
4.7.3. Attach the connectors, as shown, to both ends.
5. MAINTENANCE
5.1.
Lubricate the casters annually with bearing grease.
5.2.
Lubricate the drawer slides twice a year.
5.3.
Periodically, the drawer fronts, drawer trim and other surfaces should be cleaned with mild detergent and water.
Parts support is available for this product. To obtain a listing and/or diagram, please log on to: www.sealey.co.uk,
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Fig.3
Fig.5
email: sales@sealey.co.uk or phone: 01284 757500
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
www.sealey.co.uk
01284 757500
sales@sealey.co.uk
01284 703534
PTB104008SS, PTB105511SS
Fig.4
Issue: 1 - 16/10/14
Advertisement
