Specifications - Stanley IntelliSensor Pro Instruction Manual

109F Manual (B/E/F)
Surface Differences
Wallpaper — There will be no difference
in the function of the stud sensor on surfaces
covered with wallpaper or fabric unless the
coverings contain metallic foil or fibers.
Plaster and Lath — Unless the plaster and
lath is exceptionally thick or has metal mesh
in it there will be no problem with the unit
functioning properly.
Ceiling or Textured Surfaces — When
dealing with a rough surface such as a
sprayed ceiling, use a piece of cardboard
when scanning the surface. Run through
the calibration technique described earlier
WITH the piece of cardboard between the
stud sensor and the surface. Also, it is
particularly important in this application to
remember to keep your free hand away from
the unit.

Specifications

Utilizing the procedure of scanning and marking
from two sides, IntelliSensorTM Pro will find the
stud center typically within 1/8" accuracy for
wood and 1/4" accuracy for metal.
When measuring a wood or metal stud, it is
recommended the IntelliSensorTM Pro to be used
at 30-50% relative humidity.
Battery : 9 volt (not
included)
Shock Resistance : up to 6 feet
Operating Temperature : +32˚F to +120˚F
(0˚C to +49˚C)
Storage Temperature : -4˚F to +150˚F
(-20˚C to +66˚C)
10
10 17/2/05, 3:38 PM