Advertisement
4. OPERATION
4.1.
To Attach.
4.1.1.
Position the suction cup on the mounting surface so the red line (fig.1.3) will be visible if it should appear while lifting the load.
CAUTION: Look for deformation on painted surfaces or soft coatings. If deformation of the surface to be lifted occurs DO NOT attempt
to lift.
4.1.2.
Pump the plunger (fig.1.4) until the cup attaches completely. When the red line (fig.1.3) is hidden, vacuum is sufficient for lifting.
4.1.3.
Check the plunger frequently to make sure the cup remains securely attached. If the red line appears while lifting, immediately set
down the load and pump the plunger until the red line (fig.1.3) is hidden again.
4.2.
To Release.
4.2.1.
Set the load on a secure support.
4.2.2.
There are two methods to release the cup:
a. The preferred method, press the valve release lever (fig.1.2) for a controlled release, hold the lever down until the cup disengages
completely.
b. Pull the release tab (fig.1.1) to instantly disengage cup from mounting surface.
5. MAINTENANCE
5.1.
Always keep rubber pad clean and free of oil or grease. Clean suction pad regularly with non-aggressive cleaners.
5.2.
DO NOT expose rubber pad to sunlight over extended period of time, to preserve elasticity.
5.3.
If the cup does not function normally, the cup face may be dirty or the cup may require service. First clean the cup. If the condition
persists, contact an authorised dealer for service.
5.4.
Spare Parts (refer to Fig.1.)
Item.
1.
4.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Part No:
Description.
AK9894.02
Rubber Sucking Disc 8".
AK9894.01
Handle and Pump Assembly.
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
Original Language Version
Environmental Protection
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
AK9894 | Issue 4(L) 13/09/16
Advertisement
