Salto EC 2000 User Manual
  1. Manuals
  2. Brands
  3. Salto Manuals
  4. Media Converter
  5. EC 2000
  6. User manual

Salto EC 2000 User Manual

Rw i-button encoder
Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

RW I-Button Encoder
(EC 2000)
User's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EC 2000 and is the answer not in the manual?

Questions and answers

Related Manuals for Salto EC 2000

Summary of Contents for Salto EC 2000

  • Page 1 RW I-Button Encoder (EC 2000) User’s Manual...
  • Page 2 RW I-button. It is also used to read information from a I-button memory. The encoder is used in conjunction with the following Salto equipment to manage a complete access control system: 1.
  • Page 3 12 V DC. 500 mA. 2. Serial cable to allow communication with the PC: this cable has a female DB-9 connector on one end, which must be plugged to the serial port in the computer that has the Salto RW software installed on it.
  • Page 4 Page: 3 How to place the I-Buttons During the set up of a data base on the Salto RW software, the program will sometimes ask you to place a RW I-button on the Encoder. At this point, once the I-button has been placed, the reading/writing action will take place, then the program will ask you to remove the I-button.
  • Page 5 ALTO EC 2000 RW I-Button Encoder Page: 4 General Use You can see listed below the operations from the Salto RW software for which the Salto encoder is required; 1. To read an I-button. 2. To delete an I-button. 3. To do a check in.
  • Page 6 ALTO EC 2000 RW I-Button Encoder Page: 5 Maintenance The only maintenance the I-button encoder needs is to clean it with a damp cloth. Please, do not use abrassive soaps or solvents. When the encoder is not going to be used for a long period of time, it is recommended that the power supply be disconnected.

Table of Contents