Advertisement
NOTE: Children of less than 3 years should be kept away unless supervised continuously.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its
intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform
user maintenance.
NOTE: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
2. INTRODUCTION
A totally dry heat, no condensation, no gas, no fumes and no smell. Reaches maximum heat output within seconds of being turned on. Highly polished
aluminium reflector for maximum heat efficiency. Adjusts horizontally through 25° while mounted. Three settings, controlled by pull chain, allow the unit to be
on low, half or full power. Ideal for industrial or domestic applications. Suitable for indoor use or outdoor use, if weather protected.
3. SPECIFICATIONS
Model no: ....................................................... IWMH2003.V2
Power: .........................................................................2000W
Input supply: ......................................................... 230V 50Hz
Dimensions: ............................................485 x 250 x 170mm
4. MOUNTING/INSTALLATION
4.1.
WALL MOUNTING (fig.1).
4.1.1.
Drill 4 holes in wall to mount wall bracket (2) (refer to
dimensions in bottom right hand corner of fig.1).
4.1.2.
Place wall plugs (4) in holes.
4.1.3.
Align wall bracket (2) with holes and then fix with screws (3).
4.1.4.
Insert the wall bracket (A) into the hole (C) of the main body
(1) of the heater.
4.1.5.
Use screw knob (5) to secure the main body (1) to the wall
bracket (A).
5. OPERATION
Note: The infrared lamp is fragile and therefore it is important
that it is not subjected to any unnecessary shocks or vibration
and is not moved when it is on or until cooled down.
WARNING! Ensure you read, understand and apply the
‰
safety instructions in Section 1 before using the heater.
5.1.
Ensure the heater is at least 900mm from any object. The
heater can be tilted from 0° to 25° set it to the required angle
before switching the heater on.
5.2.
Plug in the heater and pull down on the string to switch it on.
5.3.
The heater has the following settings:
Position 0:
Position L:
Position M:
Position H:
5.4.
Make sure the heater plug is disconnected from the mains supply before any cleaning is attempted. Also allow the heater to cool
completely. Do not use water or other liquids, or harsh abrasive cleaners to clean the heater.
5.5.
Clean the exterior with a soft damp cloth with some mild detergent.
5.6.
When the heater is no longer required, switch off and unplug the unit.
5.7.
To replace any of the lamps, contact your authorised Sealey stockist.
IWMH2003.V2 is fitted with an tilt safety mechanism so that if for any reason the heater would be tilt beyond 25° the heater will
5.8.
cut-out. Position the heater upright to turn the heater back on.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Off position.
Middle element only.
Two outer elements.
All three elements.
Dispose of this product at the end of its working life in compliance with the EU Directive on
fig.1
Environmental Protectio
n
WEEE Regulations
Advertisement
