Advertisement
How to in stall the HUD.
1. Stick Velcro strip to the center of product back.
2.Stick the products with velcro strip to the holder, post the holder toward auto front glass, confirm the reflecting
position once connect to the power from the automobile.
3. Clean the reflecting position of front glass by duster cloth, in order to stick reflecting sheet.
Reflecting Sheet sticking position guide:
Tip: Do not stick the reflecting sheet in front of the driver's sight, it will affect the driving behavior,
The best position is to the bottom in front of auto glass, or the middle or bottom of the both sides, not affect the driver
sight. Best position as below
4.Tear the protective layer of the reflecting sheet, spray some water to the tearing face of sheet in order to easy to
move during the sticking. Then stick the sheet to the reflecting location (note: the inside of the front glass).
5.After adjusting the sheet to the appropriate location, using a flat card to scrape the inside water until there are no
bubbles or water inside.
1
Advertisement
Table of Contents
Summary of Contents for Quicklynks TURBOGAUGE V HUD
- Page 1 How to in stall the HUD. 1. Stick Velcro strip to the center of product back. 2.Stick the products with velcro strip to the holder, post the holder toward auto front glass, confirm the reflecting position once connect to the power from the automobile. 3.
- Page 2 6..wait a few minutes, get rid of the water sheet, gently wipe the droplets around. 7..Stick Velcro strip onto the dashboard to be fasten to the holder, adjust the holder slightly to reach the best reflecting effect. Tips: head-up display is convenient, but be sure not to stare at numbers, while ignoring traffic safety! Holder The hold can rotate vertically 90 degree, and horizontally 360 degree.
Need help?
Do you have a question about the TURBOGAUGE V HUD and is the answer not in the manual?
Questions and answers