Advertisement
Welcome
Welcome to the Speed Queen
expertly engineered to deliver commercial performance, tested to ensure ultimate durability and built with American Pride. For more than 110
years, Speed Queen consumer laundry products have been manufactured in Ripon, Wisconsin, a place where pride of workmanship is not just
alive, but thriving and embodied by each individual who designs, tests, assembles or in some way touches a Speed Queen product. A special
thing happens when that pride is combined with the highest quality commercial materials and components...it leads to the ultimate reliability...
reliability measured in decades, not years. That's legendary Speed Queen Quality.
Installation
Parts included:
1.
Position and level the dryer.
• Recommended rear clearance minimum
is 2 in (51 mm) for utility connections
and 6 in (152 mm) when venting through
rear of unit
2.
Connect exhaust system.
• Dryer must be exhausted to the outdoors
• Use 4 in (102 mm) rigid duct
• Maximum straight duct length = 65 ft
(19.8 m). Each elbow deduct 10 ft (3 m)
• Sufficient make-up air must be supplied.
The free area of any opening for outside
air must be at least 40 in
per unit
family. Thank you for your support of our truly commercial quality products. Our washers and dryers are
®
Three (3) Screws
(Electric Models)
3.
(25806 mm
)
2
2
Gas models – connect gas supply pipe.
Gas service to a gas dryer must conform
with the local codes and ordinances.
Refer to installation instructions, which can be found at speedqueendoc.net
• Tighten all connections securely but do not
overtighten to avoid breaking or bending the
gas valve bracket.
Turn on gas and check all pipe connections
(internal and external) for gas leaks by
applying a non-corrosive leak detection fluid
to the fittings. If bubbles are present then a
leak is likely.
Retighten connections and recheck
for leaks.
4.
Electric models – connect
electrical cord with three-wire
or four-wire plug.
Refer to installation instructions,
which can be found at speedqueendoc.net
5.
Wipe out inside of dryer.
6.
Plug in the dryer.
7.
Start dryer and check that
dryer is heating.
Advertisement
