Advertisement
Available languages
Available languages
FIRST USE
• Before the Single Burner is used for the first time, it should be heated up at maximum setting
for approximately 4 minutes without a pot. During this curing process, the protective coating
is hardened and obtains its maximum strength.
• The Single Burner may smoke the first time it is used- it is not defective and the smoke will
burn off within a few minutes.
• Do not leave the unit ON without any pots/pans on the Sealed Burners, after the curing pro-
cess.
• Do not use as a portable heater.
• Make sure the power supply cord does not touch hot elements or cooking utensils.
• For daily cooking, wipe excess water/condensation off pots, lids, and utensils prior to use.
• Make sure that hot pots/pans do not touch the Housing Unit - these could damage the sur-
face finish.
OPERATING INSTRUCTIONS
Before plugging in your Single Burner, check to ensure that the electrical circuit is not overloaded
with other appliances. This unit should always be operated on a separate 120 volt, AC circuit.
1.
Place unit on a flat, smooth surface. Be sure to place it in a safe area where it will not fall or
be pulled down by the cord.
NOTE: Provide at least 4 to 6 inches of space above and around the unit for proper ventilation.
2.
Plug unit into electrical outlet and turn the Temperature Control Knob(s) from OFF to the
desired setting.
3.
When using a pot or pan, you should place it in the center of the burner. It is recommended
that you use a pot or pan that is the same size as the burner.
4.
When not in use, unplug to assure the unit is OFF. This helps to prevent accidental burns.
ClEANING
1. Turn Temperature Control Knob(s) OFF.
2. Always unplug unit from electrical outlet and allow to cool before cleaning.
3. NEVER IMMERSE UNIT IN WATER OR OTHER LIQUIDS.
4. Do not attempt to separate burner from the unit.
5. Use a damp, soapy cloth or sponge to clean the surface of the sealed burners, burner rings,
legs, and housing unit. NEVER USE HARSH ABRASIVE OR STEEL WOOL PADS ON ANY
PART OF THE BURNER.
6. Thoroughly wipe soap from sealed burners and burner rings. Then dry.
7. There are no user serviceable parts. Any servicing other than cleaning should be performed
by an authorized service center.
NOTE: A short power supply cord is provided to reduce the hazards resulting from becoming
entangled in or tripping over a longer cord. If a longer cord is required, extension cords are
available and may be used if care is exercised in their use. If an extension cord is used, (1) the
marked electrical rating of the extension cord should be at least as great as the electrical rating
of the Single Burner (120V, 1100W) and (2) the longer cord should be arranged so that it will
not drape over the countertop or tabletop where it can be pulled on by children or tripped over
unintentionally. If the plug does not fit securely into the AC outlet or if the AC plug or outlet feels
warm, do not use that AC outlet.
Advertisement
