Download  Print this page

Breezaire WK1060 Installation Instructions

Wk series.
Hide thumbs
   

Advertisement

8610 Production Avenue l l San Diego, California 92121 l l (858) 566-7465 l l Fax (858) 566-1943

--INSTALLATION INSTRUCTIONS--

Thank you for choosing a BREEZAIRE cooling unit. We believe our products are the best
on the market and will provide many years of trouble-free service.
Please take a few minutes and read this entire instruction before beginning the installation.
Before removing the cooling unit from the box, please inspect for damage, which might have occurred
during shipping. If damage is found, notify the Freight Company immediately.
MODEL _____________________ SERIAL NUMBER ______________________
INSTALLED BY ______________________________ DATE__________________
While great effort has been made to provide accurate guidelines,
enclosure. Customers are cautioned that enclosure construction, unit location and many other factors can affect the operation and
performance of the unit. Therefore the suitability of the unit for a specific enclosure or application must be determined by the customer
and cannot be warranted by
BREEZAIRE Products Company - 8610 Production Avenue - San Diego, CA USA 92121 - (858) 566-7465
WK SERIES
BREEZAIRE is not responsible for any damages during shipping.
BREEZAIRE.
(USA ONLY)
cannot warrant its units to properly cool a particular
BREEZAIRE

Advertisement

Table of Contents

   Related Manuals for Breezaire WK1060

   Summary of Contents for Breezaire WK1060

  • Page 1: Installation Instructions

    Therefore the suitability of the unit for a specific enclosure or application must be determined by the customer and cannot be warranted by BREEZAIRE. BREEZAIRE Products Company - 8610 Production Avenue - San Diego, CA USA 92121 - (858) 566-7465 WK SERIES (USA ONLY)
  • Page 2 The BREEZAIRE WK Series cooling units are designed to, when installed in a properly constructed enclosure, provide a constant, selectable temperature between approximately 48°F and 63°F while reducing the excess relative humidity to the proper 50% to 75%. BREEZAIRE cooling units are designed to lower the temperature, while removing only excessive moisture.
  • Page 3 BREEZAIRE is extremely proud of the quality and reliability of its products. Experience has shown that of the small number of problems encountered, the large majority are due to improper unit selection or enclosure construction. Should the cooling system be suspected of malfunctioning, check the temperature of the air being exhausted from the upper part of the warm air exhaust condenser grille .
  • Page 4 (condenser) grille (see Fig. 3). If there is no airflow or no change in temperature on either side, contact your dealer. BREEZAIRE units should NOT be installed in a fire rated wall without consulting your local building inspector and building codes.
  • Page 5 In situations where the ambient relative humidity is very low, the desired enclosure relative humidity may not be achieved without adding moisture. To add moisture to the enclosure only use slow, natural evaporation from a small porous water container. Do not use a humidifier. Improper placement or installation may cause the unit's performance to be degraded.

This manual is also suitable for:

Wk2200Wk3000Wk4000Wk6000Wk8000Wkl1060 ... Show all

Comments to this Manuals

Symbols: 0
Latest comments: